Uscg Solid Waste Incinerator / Marine Incinerator

Description
The Incinertor,which is designed for on board incineration of ship's waste oil and solid, it mainly consists of four parts:
A. Combustion chamber with diesel oil burner, sludge burner, and electric control panel.
B. Flue gas fan
C. Flue gas damper.
D. Sludge tank with circulating pump and heater.

Details

The incinerator GRINC-18 is equipped with single door in front, which are intended for loading
Of solid waste and ash removing, the incinerator in stand-by mode(COM. Tem. Less than 220° C), the doors can be opened properly. If the incinerator is running in cooling down mode, the door can be opened till COM. Tem. Less than 100° C and incinerator fully stop.

The electrical control panel is installed on the incinerator and it contains fuses, starters, PLC and
Operator panel. The electric panel is built according to international standards for marine equipment.

The operator panel which is located at the right side of the control panel has a touch screen and
Defined keys for system starting/stopping and selecting burner modes. The burning process is controlled by the PLC and monitored by the HMI(human machine interface)and scanned by a photo resistor. The combustion chamber temperatures are also regulated automatically by the PLC control system.

Other capacity 30kg~500kg/h is available.



Please contact us to confirm the detailed incinerator required. Or Other water treatment equipment. Thanks

Rotary Vacuum Dryer

1.WORKING PRINCIPLE

Double-tapped rotary vacuum dryer is a double conical rotary tank, the tank in the vacuum state, into the jacket through steam or hot water for heating, heat through the tank wall and wet material contact. Wet material after heat evaporation of water vapor, through the vacuum pump through the vacuum exhaust pipe is pumped, because the tank is in a vacuum state, and the tank rotation of the material constantly up and down, inside and outside, so accelerate the drying speed of the material, improve drying efficiency, to achieve the purpose of uniform drying

2.FEATURES

It is a drying equipment integrating mixing and drying. The condenser, vacuum pump and dryer are matched to form a vacuum drying device (if there is no need to recover solvent, the condenser can not be used). The internal structure of the machine is simple, easy to clean, easy to operate, can reduce labor intensity and improve the working environment. At the same time, because the container itself rotates when the material also rotates, but there is no material on the wall, so the heat transfer coefficient is higher, the drying rate is large, not only save energy, and the material drying uniform and full.

3.MAIN APPLICATION

It is suitable for vacuum drying and mixing of powder and granular materials in pharmaceutical, food and chemical industries, especially for materials with the following requirements

Heat-sensitive materials that cannot accept high temperatures

Oxidized and dangerous materials

Materials requiring recovery of solvents and toxic gases

Materials with very low residual volatile content are required

Material with requirements for crystalline shape

In addition we also have other machines for u chosoe,such as spices Powder Pulverizer ,powder mixer,Capsule Filling Machine,capsule Polishing Machine,Capsule Counting Machine,tablet press,vacuum dryer etc

Dried Fruit Rotary Vacuum Dryer,Food Additive Rotary Vacuum Dryer,Synthesis of Feed Rotary Vacuum Dryer, Antibiotics Double-tapped Rotary Vacuum Dryer,Turmeric Powder Double-tapped Rotary Vacuum Drye

Jiangyin yongchang medicine machinery co,.ltd , https://www.ycgrinderline.com